Sitting down with flexiskirts [UPDATED]

  1. Drop the skirt on the ground.
  2. Right-click and select Edit
  3. Check the box that says “Edit linked parts”
  4. Right-click now on the root prim (the one in yellow)
  5. If it’s a sphere, change it to a cube
  6. Now go to the “Features” tab and activate the Flexible settings on the checkbox
  7. For best results, the parameters should be exactly like the ones on the other skirt elements (I usually select one of them, take note of all the parameters ona  piece of paper, select the root prim again, and copy them)
  8. Throw the script above inside the root prim
  9. Take the skirt back into inventory
  10. Now wear it!

Complex? A bit! So make sure you have a copyable version of your favourite skirt, I broke quite a lot of them until I figured out all the steps… but it works nicely!

Print Friendly, PDF & Email
| ← Previous | |
%d bloggers like this: